久久香蕉国产线看观看精品yw-久久香蕉国产线看观看亚洲卡-久久香蕉国产线熟妇人妻-久久香蕉影院-久久香蕉综合精品国产-久久香综合精品久久伊人

老化測試設備

咨詢熱線

18566398802
首頁 > 標準大全 > ASTM D470-99標準詳情
相關測試儀器

ASTM D470-99

(該標準已經被ASTM D470-2013替代)
  本頁面標準信息均來源于網絡收集,或由參與標準制定的供應商提供,只作為參考使用。我們愿意和您交流ASTM D470-99標準細節信息或ASTM D470-99測試方法,歡迎致電【18566398802】

ASTM D470-99標準介紹

簡介

ASTM  D470-99是交聯絕緣材料和電線\電纜外皮的老化測試標準。標準后續的數字指代標準的采用年限,或者修訂情況下最后確定修改的年份。

1. Scope

1.1 These test methods cover procedures for testing crosslinked insulations and jackets for wire and cable. To determine the test to be made on the particular insulation or jacket, reference should be made to the product specification for that type. These test methods do not apply to the class of products known as flexible cords.

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 4.

1.3 Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in the parentheses are for information only.

1.4 In many instances the insulation or jacket cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated or jacketed wire or cable in these test methods solely to determine the relevant property of the insulation or jacket and not to test the conductor or completed cable.

1.5 The procedures appear in the following sections:

AC and DC Voltage Withstand Tests22 to 29
Capacitance and Dissipation Factor Tests38 to 44
Cold Bend128
Cold Bend, Long-Time Voltage Test on Short Specimens51 to 57
Double AC Voltage Test on Short Specimens45 to 50
Electrical Tests of Insulation17 to 64
Heat Distortion Test127
Horizontal Flame Test100 to 104
Insulation Resistance Tests on Completed Cable30 to 37
Mineral Filler Content, Determination of111 to 115
Ozone Resistance Test87 to 99
Ozone Resistance Test87 to 99
Partial-Discharge Test58 to 64
Physical Tests of Insulation and Jacket Compounds5 to 16
Surface Resistivity Test116 to 120
Track Resistance Test129 to 132
U-Bend Discharge Test121 to 125
Water Absorption Test65 to 71
Water Absorption Test, Accelerated72 to 86
Water Absorption Test on Fibrous Coverings105 to 110

2. Referenced Documents

2.1 ASTM Standards: D 149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies2

D 150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulating Materials2

D 257 Test Methods for D-C Resistance or Conductance of Insulating Materials2

D 412 Test Methods for Vulcanized Rubber and Thermoplastic Rubbers and Thermostatic Elastomers—Tension3

D 454 Test Method for Rubber Deterioration by Heat and Air Pressure3

D 572 Test Method for Rubber Deterioration by Heat and Oxygen3

D 573 Test Method for Rubber—Deterioration in an Air Oven3

D 1193 Specification for Reagent Water4

D 1711 Terminology Relating to Electrical Insulation2

D 2132 Test Method for Dust-and-Fog Tracking and Erosion Resistance of Electrical Insulating Materials2

D 3755 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials Under Direct-Voltage Stress5

D 5025 Specification for a Laboratory Burner Used for Small-Scale Burning Tests on Plastic Materials6

D 5207 Practice for Calibration of 20 and 125 mm Test Flames for Small-Scale Burning Tests on Plastic Materials6 D 5423 Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation

2.2 ICEA Standard:

T-24-380 Guide for Partial-Discharge Procedure7

3. Terminology

3.1 Definitions—For definitions of terms used in these test methods, refer to Terminology D 1711.

3.2 Definition of Term Specific to this Standard:

3.2.1 aging (act of), n—exposure of material to air or oil at a temperature and time as specified in the relevant material specification for that material.

3.3 Symbol:

3.3.1 kcmil—thousands of circular mils.

溫馨提醒:本ASTM D470-99可能存在更新的版本,建議尋找ASTM D470-99的發行商確認。

符合 ASTM D470-99 標準的
老化試驗箱

近期文章
主站蜘蛛池模板: s8国产成人精品视频 | 欧美日韩中文亚洲v在线综合 | 国产免费人成在线视频视频 | 亚洲一区二区三区免费在线观看 | 亚洲综合第一欧美日韩中文 | 天天色天天 | 亚洲福利一区二区 | 伊人狼人久久 | 成人毛片18岁女人毛片免费看 | 欧美亚洲图区 | 中文字幕久久亚洲一区 | 欧美成人a视频 | 久久久久无码国产精品一区 | 尤物福利在线 | 亚洲永久精品一区二区三区 | 手机看片日韩日韩 | 亚洲一区有码 | 一区二区在线免费观看 | 爱做久久久久久久久久 | 夜色资源在线观看免费 | 波多野结衣中文字幕一区二区三区 | 999久久久国产 | 欧美资源站 | 精品久久久久亚洲 | 5x性区m免费毛片视频看看 | 欧美日韩不卡在线 | 久久免费高清视频 | 午夜禁片| 成人欧美在线观看免费视频 | 在线精品一区二区三区 | 亚洲精品中文字幕不卡在线 | 中文xxx视频| 黄色在线视频观看 | 无遮挡又黄又爽又色1000部 | 国产最新网站 | 欧美一级片网 | 啪啪网站免费 | 综合另类小说色区色噜噜 | 国产乱色| 欧美日韩大片 | 久久国产成人亚洲精品影院老金 |