久久香蕉国产线看观看精品yw-久久香蕉国产线看观看亚洲卡-久久香蕉国产线熟妇人妻-久久香蕉影院-久久香蕉综合精品国产-久久香综合精品久久伊人

老化測試設備

咨詢熱線

18566398802
首頁 > 標準大全 > ASTM D1499-2013標準詳情
相關測試儀器

ASTM D1499-2013

(該標準已經被ASTM D1499-2013替代)
  本頁面標準信息均來源于網絡收集,或由參與標準制定的供應商提供,只作為參考使用。我們?cè)敢夂湍涣鰽STM D1499-2013標準細節信息或ASTM D1499-2013測試方法,歡迎致電【18566398802】

ASTM D1499-2013標準介紹

ASTM D1499 操縱塑料暴露用曝光和暴水裝置(碳弧型)的操作規程(塑料用濾光明火碳弧型曝光裝置的標準實施規程)

ASTM D1499-2013發行信息

標準號ASTM D1499-2013

中文名操縱塑料暴露用曝光和暴水裝置(碳弧型)的操作規程

英文名Standard Practice for Filtered Open-Flame Carbon-Arc Exposures of Plastics

發布日期2013

實施日期

廢止日期無

中國標準分類號G31

國際標準分類號83.080.01 (Plastics in general)

發布單位US-ASTM

ASTM D1499-2013適用范圍

4.1 The ability of a plastic material to resist deterioration of its electrical, mechanical, and optical properties caused by exposure to light, heat, and water can be very significant for many applications. This practice is intended to induce property changes associated with end-use conditions, including the effects of sunlight, moisture, and heat. The exposure used in this practice is not intended to simulate the deterioration caused by localized weather phenomena, such as, atmospheric pollution, biological attack, and saltwater exposure.

4.2 Cautionsx2014;Variation in results may be expected when operating conditions are varied within the accepted limits of this practice. Therefore, no reference to the use of this practice shall be made unless accompanied by a report prepared in accordance with Section 9 that describes the specific operating conditions used. Refer to Practice G151 for detailed information on the caveats applicable to use of results obtained in accordance with this practice.

Note 2 Additional information on sources of variability and on strategies for addressing variability in the design, execution, and data analysis of laboratory-accelerated exposure tests is found in Guide G141.

4.2.1 The spectral power distribution of light from an open-flame carbon-arc is significantly different from that produced in light and water exposure devices using other carbon-arc configurations or other light sources. The type and rate of degradation and the performance rankings produced by exposures to filtered open-flame carbon-arcs can be much different from those produced by exposures to other types of laboratory light sources.

4.2.2 Interlaboratory comparisons are valid only when all laboratories use the same type of carbon-arc, filters, and exposure conditions.

4.3 Reproducibility of test results between laboratories has been shown to be good when the stability of materials is evaluated in terms of performance ranking compared to other materials or to a control.5,6 Therefore, exposure of a similar material of known performance (a control) at the same time as the test materials is strongly recommended. It is recommended that at least three replicates of each material be exposed to allow for statistical evaluation of results.

4.4 Test results will depend upon the care that is taken to operate the equipment in accordance with Practice G152. Significant factors include regulation of line voltage, freedom from salt or other deposits from water, temperature and humidity control, and conditions of the electrodes.

1.1 This practice covers specific procedures and test conditions that are applicable for exposure of plastics in filtered op......


4.1塑料材料抵抗因暴露于光、熱和水而導致的電氣、機械和光學性能劣化的能力在許多應用中可能非常重要。本規程旨在引起與最終使用條件相關的性能變化,包括陽光、水分和熱量的影響。本規程中使用的暴露不是為了模擬局部天氣現象造成的惡化,如大氣污染、生物攻擊和鹽水暴露。

4.2;當操作條件在本規程的可接受范圍內變化時,可預期結果的變化。因此,除非附有根據第9節編制的報告,說明所用的具體操作條件,否則不得提及本規程的使用。參考規程G151,了解適用于使用根據本規程獲得的結果的注意事項的詳細信息。注2:關于可變性來源以及解決實驗室加速暴露試驗設計、執行和數據分析中可變性的策略的附加信息,見指南G141。

4.2.1明火碳弧產生的光的光譜功率分布與使用其他碳弧配置或其他光源的光和水暴露裝置產生的光譜功率分布明顯不同。暴露于過濾明火碳弧產生的退化類型和速率以及性能等級可能與暴露于其他類型的實驗室光源產生的退化類型和速率以及性能等級大不相同。

4.2.2只有當所有實驗室使用相同類型的碳弧、過濾器和暴露條件時,實驗室間比較才有效。

4.3當根據與其他材料或?qū)φ瘴锵啾鹊男阅艿燃?jí)評估材料的穩定性時,實驗室間試驗結果的再現性已被證明是良好的。5,6因此,強烈建議在試驗材料的同時暴露具有已知性能的類似材料(對照物)。建議對每種材料至少進行三次重復,以便對結果進行統計評估。

4.4試驗結果將取決于按照規程G152操作設備時的謹慎程度。重要因素包括線路電壓調節、無鹽或其他水沉積物、溫度和濕度控制以及電極條件。

溫馨提醒:本ASTM D1499-2013可能存在更新的版本,建議尋找ASTM D1499-2013的發行商確認。

主站蜘蛛池模板: 欧美片欧美日韩国产综合片 | 国内精品久久久久不卡 | 韩国一级特黄毛片大 | 国产成人精品久久一区二区小说 | 精品国产第一国产综合精品gif | 天天躁狠狠躁狠狠躁夜夜躁 | 精品一精品国产一级毛片 | 亚洲欧美日韩国产vr在线观 | 日本强日本不卡一 | 国产成+人+亚洲+欧美+日韩 | 国产视频每日更新 | 欧美成人性色 | 国产精品久热 | 老司机午夜视频在线观看 | 四月婷婷七月婷婷综合 | ab毛片 | 另类婷婷 | 色婷婷六月桃花综合影院 | 亚洲第一成年网 | 日本免费黄色录像 | 玖玖在线精品 | 四虎影视在线免费观看 | 欧美一级毛片欧美一级无片 | 日韩欧美亚洲综合 | 国产三级做爰在线观看∵ | 香蕉视频看片 | www成人免费视频 | 寡妇一级a毛片免费播放 | 91精品国产爱久久久久久 | 一级无毛片 | 66精品综合久久久久久久 | 日韩一区二区三区不卡视频 | 久久香蕉国产线看观看式 | 中文字幕一区视频一线 | 欧美激情一区二区三区视频 | 天天拍拍天天爽免费视频 | 久草在线久草在线 | 精久久 | 91系列 | 欧美日韩精品 | 亚洲香蕉一区二区三区在线观看 |